KA-08 Remote Instructions
This shows how the PTZ EFX remote plugs into the bullet cam. KA-08 lighting filter/special FX + PTZ remote Does not need an internal battery, it gets power from the camera. The white rca female lead on the cam is not for audio, it is for the KA-08 fx remote only. If you plug audio into that jack, your adventure camera will turn to a negative reverse image look. (If you do not have the remote), plug audio back into the white jack again while your camcorder, & helmet cam are powered up to reverse the image back to normal, otherwise if you have the remote, just press the NEG/POSI button 1 time. Make sure your camcorder, and helmet cam have power on at that time. Doing so will change it back to normal. When using the remote while connected to the camera you have to press the buttons firmly with your thumbnail towards the middle of the button. To use the PTZ feature, press & hold the tele button to where you want the zoom to be set. Then press & hold pan or tilt to adjustment desired. If you press pan or tilt 1 time quickly, it will internally move by itself back & fourth/up & down until pressed again. Press & hold wide to zoom out. In darker environments, you can press the Day&Night ON/OFF button 1 time to clean the picture up a little. The brightness button has to be pressed multiple times to adjust for proper lighting. On bright days turn it down a few clicks, & on dim days, turn it up for maximum performance clarity. The NEGA/POSI will give you a special negative effect. Press 1 time to turn on and off. When you disconnect the remote from the camera, the cam will remember all the settings except the tele/pan tilt. That will reset back to normal when power is lost to the cam. You can have multiple cameras on a system, and only need 1 remote to program them.
Additional Instructions
The white rca female lead on the cam is not for audio, it is for the KA-08 fx remote only. If you plug audio into that jack, your adventure camera will turn to a negative reverse image look. (If you do not have the KA-08 remote), plug audio back into the white jack again while your camcorder, & helmet cam are powered up to reverse the image back to normal, otherwise if you have the remote, just press the NEG/POSI button 1 time. Make sure your camcorder, and helmet cam have power on at that time. Doing so will change it back to normal.
SEO Link Directory
